Infloor thermostat manual

 · MTC is an electronic heating thermostat designed to be installed in a standard single gang electrical box with a minimum width of ⁄4”. Once installed, it requires no maintenance. Type MTD: With limitation sensor for optimal comfort avoiding cold tiles during spring and autumn, or as protection against damaging wooden floors. Literature. Below is a compilation of Infloor Heating Systems product brochures, literature, installation guides, and Product Catalog, providing you more in depth information. If you have any questions or would like further assistance, please contact us directly. the thermostat is following the program/schedule. Manual means the thermostat is NOT following the program/schedule and is being controlled manually. Refer to section on page 5. Increase the temperature 6. Decrease the temperature 7. Heating indicator - when visible, system is heating 8. Access Energy Use data 9. Access Settings menu.

7 Day Intuitive Programmable Thermostat with Floor Sensor for or Volt Floor Heating Systems An "all-in-one" programmable thermostat for An "all-in-one" programmable thermostat for all electric underfloor heating applications where optimal comfort temperature and minimum energy consumption is required. The thermostat can be configured for control of floor temperature, room temperature. The STCP thermostat is designed for floor heating applications. It is compatible with all recessed or surface floor heating systems, including SCU universal heating cables, SECM concrete heating cables and Persia floor heating mats. A host of pre-programmed settings are accessible using the buttons on the front panel. Presentation. Specifications. Infloor thermostat into this electrical box. 2. Connect the wire ends into the "RELIN" terminals(2 and 5) and tighten the screws (observe polarity). See diagram below. Connect Signal Wires to Other Infloor Relays You may drive up to 10 Infloor Relays with one master Infloor t hermostat. 1.

the thermostat is following the program/schedule. Manual means the thermostat is NOT following the program/schedule and is being controlled manually. Refer to section on page 5. Increase the temperature 6. Decrease the temperature 7. Heating indicator - when visible, system is heating 8. Access Energy Use data 9. Access Settings menu. Literature. Below is a compilation of Infloor Heating Systems product brochures, literature, installation guides, and Product Catalog, providing you more in depth information. If you have any questions or would like further assistance, please contact us directly. 7 Day - Indicates the thermostat is operating in the 7 Day program selection within the automatic mode. Manual – Manual Mode Indicates the thermostat is operating in the manual mode, temperature is maintained at all times at the selected level. Sensor – Flashes when the Floor Sensor is malfunctioning.