Fiamm battery installation manual

Safety instructions AIM OF THIS MANUAL This manual is designed for use by any skilled worker wishing to use Fiamm Motive Power Premium ES battery chargers for recharging lead/acid vented, (with or without electrolyte mixing),valve regulated AGM and gel batteries. This manual provides details of: † The chargers’ functions. FIAMM S.p.A. reserves the right to change or revise without notice any information or detail given in this publication. Page 4 of 4 FIAMM Industrial Batteries Installation Operating Instruction -Technical Manual Edition 01/ - EMEA OPERATING FEATURES ♦ Capacity The battery capacity is rated in ampere hours (Ah) and. FIAMM Standby Batteries Installation Operating Instruction -Technical Manual. battery when it is operating under float conditions, reverse into the discharge mode. ♦. Battery room requirements • The battery room should be dry, well ventilated and have its temperature as moderate as the climate will allow, preferably between 10°C and 30°C.

BATTERY INSTALLATION Installation Battery room requirements. Page 2 of 2 This document and the confidential information it contains shall be distributed, routed or made available solely with written permission of FIAMM. FIAMM S.p.A. reserves the right to change or revise without notice any information or detail given in this publication. FIAMM SD SDH Features: Pasted flat plate design. 20 years design life in float operation in temperature controlled environments. Excellent for high current discharge (1 to 60 min), and medium to long discharge (2 to 10 hours) Up to 36 month watering intervals when operated under float condition. Also available in dry charged version. Drill the holes with a drill bit that matches the sheet metal screws for the installation. Connect the new horns to the wiring harness and wrap all exposed connections with electrical tape. Wrap the jumper wires with electrical tape from the horn to the harness. Secure the jumper wires to the car with wire ties. Connect the negative battery cable.

FIAMM Standby Batteries Installation Operating Instruction -Technical Manual Edition 01/ - EMEA ♦ Internal impedance and short circuit current The internal impedance of a lead acid battery is a direct result of the type of internal construction, plate thickness, number of plates, separator material. FIAMM S.p.A. reserves the right to change or revise without notice any information or detail given in this publication. 5 FIAMM Standby Batteries Installation Operating Instruction -Technical Manual ♦ Service life According to the main international standards a battery is considered at the end of its service life whenever delivering less. Racks for battery installation (standard and anti-seismic) Monitoring system 0 5 10 20 oltage 0 [hours] [%] 15 Voltage % 50% Recharged Capacity % 50% Current 50% ent 60 80 40 20 0 C10 C10 [A] [V/Cell] 40°C 5°C 30°C 20°C 0 2 4 6 8 10 12 70 80 90 The battery can be used without.